Nochmal Z3M Hinterachse

Mikes 318iS Cabrio, Sonntag, 01.10.2017, 14:01 (vor 2639 Tagen) @ Tobi_M50

Hab mir nochmal die Mühe gemacht die Seite zu suchen wo ich meine Infos damals her hatte.

http://www.extradrei.com/?p=141

Da sind Bilder von verschiedenen Hinterachslenkern und wie weit die raus stehen etc.
Leider alles in englisch, dafür ziemlich ausfühlich.

Hier der Ausschnitt zu den z3m Achsschenkeln (steht allerdings noch viel mehr auf der Seite):

5. MZ3

Geometrically, these TAs are exactly the same as Z3(I6) from previous section. They’re 20mm wider, than all other trailing arms. Unlike all other trailing arms, MZ3 got giant wheel bearings and e36 M3 hubs and brakes. Significance of getting e36 M3 hubs is, that hubs are the same height as standard e30 hub, which results in ET0 additional offset. Do quick math and you’ll see that final offset of using MZ3 rear results in ET40 final result. ALSO, these TA’s are reinforced with A-support beam, and extra support at the shock mounting and bearing housing.

Unlike Z3(I6), you can use this option. Along with trailing arms, you must also use: CV axles and Diff Flanges from MZ3.

--